在模拟生物柴油反应时出现这个警告怎么办
在模拟生物柴油反应时出现这个警告怎么办->Processing input specifications ...
->Finished processing new specifications
->Calculations begin ...
Block: RCSTR Model: RCSTR
**ERROR
RES TIME LOOP FAILED ON THE FIRST ITERATION BECAUSE
THE M-BAL LOOP DID NOT CONVERGE.
* WARNING
AT INNER LOOP ITERATION NUMBER 50 :
REACTION RATE IS GREATER THAN ZERO FOR REACTION (1) BUT
REACTANT "LAG" IS NOT PRESENT.POSSIBLE CAUSE:
ZEROTH ORDER REACTANT NOT PRESENT.RATE IS SET TO ZERO.
* WARNING
AT INNER LOOP ITERATION NUMBER 50 :
REACTION RATE IS GREATER THAN ZERO FOR REACTION (2) BUT
REACTANT "CH4O" IS NOT PRESENT.POSSIBLE CAUSE:
ZEROTH ORDER REACTANT NOT PRESENT.RATE IS SET TO ZERO.
* WARNING
AT INNER LOOP ITERATION NUMBER 50 :
REACTION RATE IS GREATER THAN ZERO FOR REACTION (3) BUT
REACTANT "PAG" IS NOT PRESENT.POSSIBLE CAUSE:
ZEROTH ORDER REACTANT NOT PRESENT.RATE IS SET TO ZERO.
* WARNING
AT INNER LOOP ITERATION NUMBER 50 :
REACTION RATE IS GREATER THAN ZERO FOR REACTION (4) BUT
REACTANT "CH4O" IS NOT PRESENT.POSSIBLE CAUSE:
ZEROTH ORDER REACTANT NOT PRESENT.RATE IS SET TO ZERO.
* WARNING
AT INNER LOOP ITERATION NUMBER 50 :
REACTION RATE IS GREATER THAN ZERO FOR REACTION (5) BUT
REACTANT "CH4O" IS NOT PRESENT.POSSIBLE CAUSE:
ZEROTH ORDER REACTANT NOT PRESENT.RATE IS SET TO ZERO.
* WARNING
AT INNER LOOP ITERATION NUMBER 50 :
REACTION RATE IS GREATER THAN ZERO FOR REACTION (6) BUT
REACTANT "CH4O" IS NOT PRESENT.POSSIBLE CAUSE:
ZEROTH ORDER REACTANT NOT PRESENT.RATE IS SET TO ZERO.
* WARNING
AT INNER LOOP ITERATION NUMBER 50 :
REACTION RATE IS GREATER THAN ZERO FOR REACTION (7) BUT
REACTANT "PG" IS NOT PRESENT.POSSIBLE CAUSE:
ZEROTH ORDER REACTANT NOT PRESENT.RATE IS SET TO ZERO.
* WARNING
AT INNER LOOP ITERATION NUMBER 50 :
REACTION RATE IS GREATER THAN ZERO FOR REACTION (8) BUT
REACTANT "CH4O" IS NOT PRESENT.POSSIBLE CAUSE:
ZEROTH ORDER REACTANT NOT PRESENT.RATE IS SET TO ZERO.
**ERROR
BLOCK RCSTR IS NOT IN MASS BALANCE:
MASS INLET FLOW = 0.72130223E+00, MASS OUTLET FLOW = 0.38193774E+02
RELATIVE DIFFERENCE = 0.51951139E+02
Block: FLASH Model: FLASH2
->Simulation calculations completed ...
***Warning(s) were issued during Input Translation ***
***Check the Run Status Results for more Information ***
***Summary of Simulation Errors***
Physical
Property System Simulation
Terminal Errors 0 0 0
Severe Errors 0 0 0
Errors 0 0 8
Warnings 0 0 32
楼主解决了吗？我也有相似的错误。
页:
[1]