求帮助 这个怎么改？求大神帮帮忙
WARNING IN PHYSICAL PROPERTY SYSTEMPARAMETER RKTZRA/ELEMENT1 (DATA SET 1)
LOWER BOUND VIOLATED FOR COMPONENT MGO
VALUE =0.22090E-01, LOWER BOUND =0.60000E-01
* WARNING IN PHYSICAL PROPERTY SYSTEM
PARAMETER PLXANT (DATA SET 1) FOR COMPONENT MGO:
UNREASONABLE VAPOR PRESSURE CALCULATED AT NORMAL BOILING POINT.
VALUE SHOULD BE WITHIN 10% OF 1D5 N/SQM.PLEASE CHECK YOUR INPUT
FOR THE ANTOINE PARAMETERS.
* WARNING IN PHYSICAL PROPERTY SYSTEM
PARAMETER PLXANT (DATA SET 1) FOR COMPONENT MGO:
UNREASONABLE VAPOR PRESSURE CALCULATED AT TEMPERATURE UPPER BOUND.
VALUE SHOULD BE LESS THAN MAXIMUM ALLOWABLE VALUE
=0.10000E+36 N/SQM.PLEASE CHECK YOUR INPUT FOR THE
ANTOINE PARAMETERS.
* WARNING WHILE CHECKING INPUT SPECIFICATIONS
BLOCK NAME: H MODEL NAME: RSTOIC
PHYSICAL PROPERTY PARAMETER DHFORM OR DHAQFM IS MISSING
FOR THE FOLLOWING COMPONENTS:
CASO4
ABSENCE OF THIS PARAMETER WILL RESULT IN INCORRECT ENTHALPY RESULTS.
* WARNING WHILE CHECKING INPUT SPECIFICATIONS
INCONSISTENT FREE-WATER DETECTED FOR STREAM "28"
GLOBAL FREE-WATER: NO
BLOCK "H" FREE-WATER: YES
* WARNING WHILE CHECKING INPUT SPECIFICATIONS
INCONSISTENT FREE-WATER DETECTED FOR STREAM "23"
GLOBAL FREE-WATER: NO
BLOCK "H" FREE-WATER: YES
* WARNING WHILE CHECKING INPUT SPECIFICATIONS
INCONSISTENT FREE-WATER DETECTED FOR STREAM "16"
FROM BLOCK: "G"FREE-WATER: NO
TO BLOCK: "H"FREE-WATER: YES
1MGO蒸汽压不太对，需要修改一下
2CASO4缺少两个焓值，物性参数里可以自己补上
3你在全局设定里设定没有自由水，但是在H这个模块里设定的是有自由水，矛盾了，去模块或全局设定里修改一下
vovovv011 发表于 2017-4-8 23:45
1MGO蒸汽压不太对，需要修改一下
2CASO4缺少两个焓值，物性参数里可以自己补上
3你在全局设定里设定没有 ...
真诚的感谢你我想问问这个怎么修改的刚开始学 不太懂这个 wangxg 发表于 2017-4-9 14:21
真诚的感谢你我想问问这个怎么修改的刚开始学 不太懂这个
谢谢你了 我把第三个问题解决了 vovovv011 发表于 2017-4-8 23:45
1MGO蒸汽压不太对，需要修改一下
2CASO4缺少两个焓值，物性参数里可以自己补上
3你在全局设定里设定没有 ...
那个 请问，mgo不是aspen自己识别的么，就是说它包含在数据库里，不应该出现蒸气压不对的情况和缺少安托尼方程的情况呀。最近我也遇到这个问题，希望能解答下，不胜感激{:1106_382:} 66666666666666666 您好，请问一下最后怎么解决的吗？
、
页:
[1]