Aspen 求助，C4H8制取C4H10O
rt学了4天左右的aspen，每模拟一次就感觉自己有缺陷的地方，然后再去看对应的资料，可是这个我就是没看懂，求帮忙
正丁烯直接水和法制取仲丁醇
aspen11.1
这是流程，流股1为水，流股2为正丁烯，加热到160摄氏度，加压到6Mpa，从水和反应器出来降温分层，水循环利用，然后精馏，得到粗仲丁醇，丁烯一部分排出，一部分循环利用
下面是结果，我们模拟了好几次，都不对。。麻烦大牛帮个忙~~~~
<< Loading Simulation Engine 16:22:30 Fri May 24, 2013>>
->Processing input specifications ...
*** SEVERE ERROR IN THE "BLOCK" PARAGRAPH WHICH BEGINS ON LINE 168
BLOCK NAME: B8 MODEL NAME: COMPR SKW: PERFOR-PARAM TKW:
HEAD-UNITS
"METER-HEAD" HAS NOT BEEN DEFINED AS A VALID
SYMBOL.PROBABLE SPELLING ERROR.
PARAGRAPH IGNORED.
**ERROR IN THE "BLOCK" PARAGRAPH WHICH BEGINS ON LINE 168
BLOCK NAME: B8 MODEL NAME: COMPR SKW: HEAD-TABLE
VALUE ENTERED FOR TERTIARY KEYWORD: CURVE
IS: 1, WHICH IS GREATER THAN THE UPPER
LIMIT OF: 0.VALUE SET TO UPPER LIMIT.
**ERROR IN THE "BLOCK" PARAGRAPH WHICH BEGINS ON LINE 168
BLOCK NAME: B8 MODEL NAME: COMPR SKW: HEAD-TABLE
VALUE ENTERED FOR TERTIARY KEYWORD: CURVE
IS: 1, WHICH IS GREATER THAN THE UPPER
LIMIT OF: 0.VALUE SET TO UPPER LIMIT.
**ERROR IN THE "BLOCK" PARAGRAPH WHICH BEGINS ON LINE 168
BLOCK NAME: B8 MODEL NAME: COMPR SKW: HEAD-TABLE
VALUE ENTERED FOR TERTIARY KEYWORD: CURVE
IS: 1, WHICH IS GREATER THAN THE UPPER
LIMIT OF: 0.VALUE SET TO UPPER LIMIT.
**ERROR IN THE "BLOCK" PARAGRAPH WHICH BEGINS ON LINE 168
BLOCK NAME: B8 MODEL NAME: COMPR SKW: HEAD-TABLE
VALUE ENTERED FOR TERTIARY KEYWORD: CURVE
IS: 1, WHICH IS GREATER THAN THE UPPER
LIMIT OF: 0.VALUE SET TO UPPER LIMIT.
*** SEVERE ERROR
BLOCK: "B8" APPEARS IN THE FLOWSHEET, BUT
NO BLOCK PARAGRAPH HAS BEEN ENTERED FOR IT.
! Errors while processing input specifications
把B12换成radfrac算，这个体系有共沸。 tdl522 发表于 2013-5-24 16:44
把B12换成radfrac算，这个体系有共沸。
好的，谢谢，我马上去试试。。
tdl522 发表于 2013-5-24 16:44
把B12换成radfrac算，这个体系有共沸。
试了一下还是出错{:1106_361:}
页:
[1]