物料不平衡的能否EO input设置该怎么设置

sonic0519

我目前做了个n多循环的工艺，做了n遍下面几个模块物料不守恒，是否可在EO input里面设置，但是该怎么设置呢 ？我从来没用过，有高人指点吗！

  **  ERROR
      BLOCK B3 IS NOT IN MASS BALANCE:
      MASS INLET FLOW = 0.12492302E-02, MASS OUTLET FLOW = 0.12500000E-02
      RELATIVE DIFFERENCE = 0.61625617E-03
      A STREAM FLOW MAY HAVE BEEN CHANGED BY A FORTRAN, TRANSFER,
      OR BALANCE BLOCK AFTER THE BLOCK HAD BEEN EXECUTED.

  **  ERROR
      BLOCK B4 IS NOT IN MASS BALANCE:
      MASS INLET FLOW = 0.41572882E-03, MASS OUTLET FLOW = 0.41587663E-03
      RELATIVE DIFFERENCE = 0.35555643E-03
      A STREAM FLOW MAY HAVE BEEN CHANGED BY A FORTRAN, TRANSFER,
      OR BALANCE BLOCK AFTER THE BLOCK HAD BEEN EXECUTED.

  **  ERROR
      BLOCK B0 IS NOT IN MASS BALANCE:
      MASS INLET FLOW = 0.27507141E-02, MASS OUTLET FLOW = 0.27503362E-02
      RELATIVE DIFFERENCE = 0.13742534E-03
      A STREAM FLOW MAY HAVE BEEN CHANGED BY A FORTRAN, TRANSFER,
      OR BALANCE BLOCK AFTER THE BLOCK HAD BEEN EXECUTED.

sonic0519

隐身猪 发表于 2013-3-8 13:26

                               
登录/注册后可看大图

在tear中把tolerance改小点试试。

这个我已经改过了。。

箬ю葙倁

楼主这个问题解决没？。。。求指教呀。。。EO input这该怎么设置呢

1592203609

同求指导！求

donggua

EO INPUT在哪个地方啊