aspenplus模拟求助

ttsherry · 发表于 1970-1-1 08:00:00

在aspenplus模拟时，液固分离采用 CFUGE模型，结果显示错误，请问怎么解决啊？
WARNING IN THE "STREAM" PARAGRAPH WHICH BEGINS ON LINE 93
   STREAM NAME: V-ORE
   THE SUM OF ATTRIBUTED COMPONENT VALUES IS NOT 100.0 FOR
   COMPONENT: ORE    TYPE: GENANAL
   IN SUBSTREAM NC    OF STREAM V-ORE
   INPUT VALUES WILL BE NORMALIZED

  * WARNING WHILE CHECKING INPUT SPECIFICATIONS
   BLOCK NAME: CRYSTALL MODEL NAME: CRYSTALLIZER
   PHYSICAL PROPERTY PARAMETER DHFORM OR DHAQFM IS MISSING
   FOR THE FOLLOWING COMPONENTS:
      NH4VO-01
   ABSENCE OF THIS PARAMETER WILL RESULT IN INCORRECT ENTHALPY RESULTS.

  **  ERROR WHILE CHECKING INPUT SPECIFICATIONS
   BLOCK NAME: FL1 MODEL NAME: CFUGE
   PSD ATTRIBUTE TYPE IS NOT PRESENT IN SUBSTREAM CISOLID
   PSD REQUIRED WHEN AVG PARTICLE DIAMETER IS NOT ENTERED.

  **  ERROR WHILE CHECKING INPUT SPECIFICATIONS
   BLOCK NAME: FL1 MODEL NAME: CFUGE
   PSD ATTRIBUTE TYPE IS NOT PRESENT IN SUBSTREAM NC
   PSD REQUIRED WHEN AVG PARTICLE DIAMETER IS NOT ENTERED.

chenhaijunsjy · 发表于 1970-1-1 08:00:00

好资料，收藏！谢谢楼主。