htri计算出现问题，谁能帮忙解答解答？？？

WARNING-Cross flow velocity exceeds critical velocity, indicatingprobability of fluid elastic instability and flow-induced vibration damage. Ifpresent, fluid elastic instability can lead to large amplitude vibration andtube damage.

WARNING-Cross flow速度超过临界速度时,指示fluidelastic不稳定和流激振动损伤的概率。 如果存在,fluid elastic不稳定会导致大的振幅振动和管损坏。

WARNING-Cross flow velocity at baffle tip exceeds critical velocity,indicating a probability of fluid elastic instability and flow-inducedvibration damage. If present, fluid elastic instability can lead to largeamplitude vibration and tube damage.

WARNING-折流板处Cross flow速度超过临界速度,指示fluidelastic不稳定和流激振动损伤的概率。 如果存在,fluid elastic不稳定会导致大的振幅振动和管损坏。

Cross flow velocity exceeds 80% of critical velocity, indicatingthat fluid elastic instability and flow-induced vibration damage are possible. Fluidelastic instability can lead to large amplitude vibration and tube damage.

横向气流速度超过临界速度的80%,表明fluid elastic不稳定和流激振动损伤是可能的。 Fluid elastic不稳定会导致大的振幅振动和管损坏。

NOTE-Tube vibration from vortex shedding is possible. Check the crossflow-induced vibration amplitude on Line 27 of the Vibration Analysis reportfor an asterisk. If no asterisk prints, probability of tube damage is low.

从涡旋脱落NOTE-Tube振动是可能的。 27行检查cross flow-induced振动振幅振动分析报告的星号。 如果没有星号打印,管损伤的概率很低。

WARNING-Bundle exit velocity exceeds critical velocity, indicating aprobability of fluid elastic instability and flow-induced vibration damage. Ifpresent, fluid elastic instability can lead to large amplitude vibration andtube damage.

WARNING-Bundle出口速度超过临界速度时,指示fluidelastic不稳定和流激振动损伤的概率。 如果存在,fluid elastic不稳定会导致大的振幅振动和管损坏。

WARNING-Shell exit velocity exceeds critical velocity, indicating aprobability of fluid elastic instability and flow-induced vibration damage. Ifpresent, fluid elastic instability can lead to large amplitude vibration andtube damage.

WARNING-Shell出口速度超过临界速度时,指示fluidelastic不稳定和流激振动损伤的概率。 如果存在,fluid elastic不稳定会导致大的振幅振动和管损坏。

Xvib can be used for a more detailed analysis of individual tubes inthe bundle.

Xvib可用于个人管的更详细的分析包。

The inlet baffle spacing is less than the recommended minimumspacing.  Check the design. Thiscondition may lead to problems when the exchanger is built.

入口挡板间距小于推荐的最小间距。 检查设计。这种情况可能会导致换热器时建立的问题。

Setting plan error: Axialnozzle location is not supported by setting plan calculation code.

不支持设置计划错误:轴向喷嘴位置通过设置计划计算代码。