氯乙烯精馏模拟中出现了错误，不知道怎么修改，求大神帮忙。

战线火龙sky · 发表于 1970-1-1 08:00:00

{:1106_361:}{:1106_361:}{:1106_361:}求大神帮忙啊！！！！
**  ERROR
   BLOCK FL-1 IS NOT IN MASS BALANCE:
   MASS INLET FLOW = 0.11132031E+01, MASS OUTLET FLOW = 0.11096759E+01
   RELATIVE DIFFERENCE = 0.31785294E-02
   MAY BE DUE TO A TEAR STREAM OR A STREAM FLOW MAY HAVE
   BEEN CHANGED BY A FORTRAN, TRANSFER, OR BALANCE BLOCK
   AFTER THE BLOCK HAD BEEN EXECUTED.

  **  ERROR
   BLOCK T1-FEED IS NOT IN MASS BALANCE:
   MASS INLET FLOW = 0.12785342E+01, MASS OUTLET FLOW = 0.12754115E+01
   RELATIVE DIFFERENCE = 0.24483788E-02
   MAY BE DUE TO A TEAR STREAM OR A STREAM FLOW MAY HAVE
   BEEN CHANGED BY A FORTRAN, TRANSFER, OR BALANCE BLOCK
   AFTER THE BLOCK HAD BEEN EXECUTED.

  **  ERROR
   Convergence block $OLVER01 did not converge
   normally in the final pass

附件里有Aspen原件，求帮助！！

下载地址

氯乙烯精馏工序物料及能量衡算.bkp

2017-4-23 17:05 大小：171.81 KB 下载次数：13

战线火龙sky · 发表于 1970-1-1 08:00:00

求大神来帮忙

战线火龙sky · 发表于 1970-1-1 08:00:00

{:1106_364:}

郭妞妞 · 发表于 1970-1-1 08:00:00

11111

智慧 · 发表于 1970-1-1 08:00:00

试试看，帮你调调。

战线火龙sky · 发表于 1970-1-1 08:00:00

智慧发表于 2017-4-26 15:54
试试看，帮你调调。

好的，太感谢了

不会aspennm · 发表于 1970-1-1 08:00:00

不会aspennm · 发表于 1970-1-1 08:00:00

氯乙烯精馏模拟中出现了错误，不知道怎么修改，求大神帮忙。

相关帖子

回帖奖励 +1

回帖奖励 +1

回帖奖励 +1


7	回复本帖可获得 1 奖励! 每人限 1 次(中奖概率 80%)