本人aspen 模拟出错不知道怎么解决。求大神们帮助

夜幕 · 发表于 1970-1-1 08:00:00

tdl522 · 发表于 1970-1-1 08:00:00

->Calculations begin ...

Block: B1    Model: SEP

Block: B4    Model: PUMP

> Beginning Convergence Loop $OLVER01 Method: WEGSTEIN
  Converging tear streams: 9

Block: B2    Model: RADFRAC

   Convergence iterations:
         Iter    Err/Tol
            0    0.18376E+07
            1    0.92052E+06
            2    0.61412E+06
            3    0.24598E+06
            4    23691.
            5    377.61
            6    0.88046E-01

Block: B8    Model: HEATER

Block: B3    Model: PUMP

Block: B9    Model: SEP

Block: B11    Model: MIXER

Block: B5    Model: HEATER

> Loop $OLVER01 Method: WEGSTEIN    Iteration 1
  Converging tear streams: 9
# Converged             Max Err/Tol  -0.11219E-06

Block: B7    Model: PUMP

->Generating block results ...

Block: B4    Model: PUMP

Block: B7    Model: PUMP

Block: B8    Model: HEATER

Block: B3    Model: PUMP

Block: B5    Model: HEATER

->Simulation calculations completed ...

  ***  No Warnings were issued during Input Translation ***

  ***  No Errors or Warnings were issued during Simulation ***

第三工段.apwz (35.61 KB, 下载次数: 11)

夜幕 · 发表于 1970-1-1 08:00:00

打不开啊！！！

夜幕 · 发表于 1970-1-1 08:00:00

tdl522 发表于 2013-7-8 10:57
->Calculations begin ...

本人的是7.3版本的太高级了打不开啊
- 本文出自马后炮化工论坛，原文地址：http://meng.horse/thread-69063-1-1.html

本人aspen 模拟出错 不知道怎么解决。求大神们帮助

点评

本人aspen 模拟出错不知道怎么解决。求大神们帮助