求助吸收问题

教育局长123 · 发表于 1970-1-1 08:00:00

*** SEVERE ERROR
   THE FOLLOWING STAGES DRIED UP (VAPOR OR LIQUID FLOW APPROACHES 0):
      1 2 3 4 5 6 7 8 9 10
   A LIMIT OF  0.10000E-04 * SUM OF FEEDS WAS IMPOSED ON THE FLOW RATES
   OR A LIMIT OF  0.10000E-04 WAS IMPOSED ON THE STAGE V/L OR L/V RATIO.

> Loop $OLVER01 Method: WEGSTEIN    Iteration 30
  * WARNING
   CONVERGENCE BLOCK $OLVER01 NOT CONVERGED IN 30 ITERATIONS

  5 vars not converged, Max Err/Tol  -0.24148E+03
  **  ERROR
   BLOCK RAD IS NOT IN MASS BALANCE:
   MASS INLET FLOW = 0.75192488E+01, MASS OUTLET FLOW = 0.74764531E+01
   RELATIVE DIFFERENCE = 0.57240546E-02
   MAY BE DUE TO A TEAR STREAM OR A STREAM FLOW MAY HAVE
   BEEN CHANGED BY A FORTRAN, TRANSFER, OR BALANCE BLOCK
   AFTER THE BLOCK HAD BEEN EXECUTED.

  **  ERROR
   Convergence block $OLVER01 did not converge
   normally in the final pass
这个怎么破

2013qustgm205 · 发表于 1970-1-1 08:00:00

从上往下说，显示严重错误，1到10干板，然后警告是模块30次迭代不收敛，然后错误是模块质量不守恒，最后一个错误是不收敛。

杞╃埜 · 发表于 1970-1-1 08:00:00

严重错误提示你塔干板了

杞╃埜 · 发表于 1970-1-1 08:00:00

上传bkp文件看看

伟少麽麽哒 · 发表于 1970-1-1 08:00:00

我也是这个问题